The Microduino LED Matrix module integrates six WS2812 lights and each light has an IC control chip inside. Six lights adopt single bus control, so you can control each light with one I/O port, which can offer optical source for full-color modules.
Adopt six WS2812 lights as the optical source.
An analog port can flexibly operate the color of several colored LED lights.
Open hardware circuit design and Arduino compatible IDE.
With uniform Microduino interface standard and rich peripheral modules, it can flexibly connect with other modules and sensor.
2.54mm (0.1 inch) pin pitch, compatible with bread boards and pegboards.
Controlled by Analog port on the back with A0, A1, A2, A3, A6 and A7 for option. A0 is the default pin.
The tricolor of each pixel can realize brightness display of 256 level and complete 16,777,216 kinds of full color display and no less than 400hz/s scanning frequency.
With built-in signal shaping circuit, any pixel receives signal and then outputs after signal shaping, ensuring the circuit wave will not accumulate.