Skip to content
nRF module (DIY)
Add to cart
2.4G wireless communication module is compatible with the DIY series.
Fully integrated link layer on the module makes it easy to develop.
With automatic retransmission function, it can automatically detect and resend lost packets and the retransmission time and frequency can be controlled by software.
With packets that can automatically save un-received response signals.
With automatic reply function, the module can send response signal automatically after receiving valid data and need no reprogramming.
Capable of setting six receiving channels' address synchronously and opening the receiving channels selectively.
Standard pin 2.54mm spacing interface, making it convenient for embedded application.
Small, stackable and economic.
Open source hardware circuit design and Arduino compatible programming development environment.
With a uniform Microduino interface standard and rich peripheral modules, it can easily connect with other Microduino modules and sensors.
2.54mm(0.1 inch) pin pitch, compatible with bread boards and pegboards.
Global open 2.4GHz ISM band with the maximum transmission power of 0DBM and free license to use.
Low operation voltage: 1.9-3.6 V.
SMA antenna, easy to change.
Support six channels' data transmission.
High rate: 2MBPS. Due to short transmission rate in the air, it largely reduces collision in wireless transmission. (Set 2MBPS or 256 KBPS, 1 MBPS air transmission rate with software)
Multi-point frequency: With 125 frequency points, it meets the requirement of multi-point communication and frequency hopping communication.
Low consumption: With fast air transmission and startup, it greatly reduces the current consumption when communicating in the response mode.
Share on Facebook
Tweet on Twitter
Pin on Pinterest